3 Way Ball Valves

3 Way Stainless Steel Ball Valves are a good way to divert or mix flow with only one valve instead of two and a Tee Fitting. The L-Type design allows for a center in port, and a simple swing of the ball valve to switch ports. (It can shut off all flow) The T-Type design can do this as well and also allow the opposing ports to open straight through. It can also do all 3 ports open at once. (It cannot shut off all flow)

• Advantages:
• ● Can divert or mix flow without the need of a Tee Fittings and two separate ball valves
•  Consideration:
• ● Reduced Port, ID is one size smaller.

Features:

• ● Suitable Mediums: Water, Oil, Gas (WOG)
• ● Threads: Female NPT 
• ● Seal: PTFE (Teflon) 
• ● Port: Reduced Port 
  
• ● Handle: Blow-Out Proof 
• ● Locking Device: Handle Can be locked open or closed (remove-able)
• ● Pressure: 1000 PSI (6.4MPa)
• ● Temperature: -13°F  to 302°F 

3-Way Ball Valve Dimensions:

• ● Since these are made from One-Piece with three caps attached to each port end, they cannot accept as large a ball as the 2 & 3 Piece can.
• ● This makes their internal diameter (ID) smaller than the full port, however they are not as reduced as the one piece standard port is.

3 Way Ball Valve Material List:

• ● All Wetted parts touching the material being transported are manufactured form long lasting Stainless Steel 316.
• ● The Seal & Seats are made out of Teflon (PTFE). This makes these robust 3-Way valves high temperature and chemical resistant.

Specifications: